EXTERNAL ENCLOSURE USER'S MANUAL

Model: HD-D4-U2

A. Hardware Installation Guide

1. Items to be installed:

A. body case
B. hard drive
C. back cover with pc board
D. screws

2. Install the hard drive to the IDE slot on the pc board (printed side of the hard
drive faces up; please refer to the picture shown below)

3. Insert the HD along with pc board into the body case

4. Screw the back cover firmly to the body case

5. Connect USB cable to the USB port

6. Please connect both USB plugs to USB ports of the computer to obtain
enough power

* If USB could not provide enough power, please use a DC 5V 2A power
adaptor.

B. Driver Installation Guide

• No Driver required in Windows ME / Windows 2000 / Windows XP operating system.

• For Windows98SE

(Make sure the external device is disconnected before the installation)

1. Please insert the CD into CD-ROM.

2. An auto run menue will show up, please select "2.5"External Enclosure / Manual", then click
"HD-D4-U2(Driver for Win98)", the driver will be installed automatically.

The steps are shown as below :


2-1

Select the language

2-2

Click "Next"

2-3

Select folder where Setup will install files (C:\Program Files\USBToolbox) then click "Next"

2-4

Select program folder (USB Storage Toolbox) then click "Next"

2-5

Installing driver

2-6

Restart computer

3. After restarting the system, connect the enclosure to the computer,
the system will be finding new hardware and install it.

4. Installation is complete.

C. Driver Installation Guide (FOR MAC)

Support only Mac OS 9.X and above version (PnP), no driver installation is needed.